A little water leak may create a lot of damage to your home, and it usually stays undetected until it’s too late, at which point it’s too late, and you’ll need to pay for expensive fixings. Ceilings, carpets, and walls can be expensive to restore. You’d be shocked to know that even small fixings can cost thousands of dollars.
Things to Check to Prevent Water Damage
As a property owner, you must always know how to keep your property safe from water damage. We’ll show you how to prevent water damage in a few simple steps:
1. Check your toilets.
Look for any water that shouldn’t exist on the floor. Remove the tank’s top and make sure that the float is adjusted to the right level (usually indicated by the letters WL on the inside). So it is not overrunning into the overflow pipe. Usually, all it takes is a small adjustment. Leak detection and repair can save you a lot of money and time.
2. Check your plumbing system.
Check your plumbing, particularly your water pipes, both inside and outside your property. Check the area around your sinks, basins, and cabinets. Check under your sink for puddles or leaks from your pipes; also, plug your sinks and fill them up, then remove the plug and check for leaks underneath. If there is any water under, look for the source of the leak; it could be a simple dripping faucet or a leaking waste that is easily repaired. Click this link to learn more about water damage restoration.
3. Check your hot water cylinder.
Look for leaks, wet patches on the flooring, or even little jets of water as you inspect the valve work. Also, ensure the water isn’t pouring out of the air vent on low-pressure open vented hot water cylinders.
4. Water valves.
Most importantly, make sure that you and your family know where to shut off the water in an emergency situation. Knowing where your water shutoff valve is located could save you thousands of dollars in the future. There will usually be a shutoff valve in the front of your property (usually on the Council edge) with a blue lid to identify it if you have reticulated water (town supply). Furthermore, a water pump and the water tank shutoff valve must be switched off on the house with a non-reticulated water system (your water comes from storage tanks).
5. Check your roofing.
Check your roof and spout outside of your home for any problems. Routinely clear out all fallen leaves from your spouting, as blocked spouting, especially inner gutters, can cause significant water damage to your ceilings. Additionally, check roof penetrations such as chimneys and flues, especially flashings.
Loose nails or screws, damaged flashings, or perhaps gaps under flashings are all signs of roof problems. Look for wet patches on your ceiling also. Roof leaks, even little ones, can quickly cause severe ceiling and structural damage. Tek screws can replace loose nails, and Plumbers Roofing Silicone can be used to reseal flashings. If you’re looking for disaster restoration services, check this out.
You have to remember that it is better to be safe than sorry. Have it repaired as soon as possible or repair it yourself if you notice any sign of a water leak anywhere, despite how small it appears to be. You may put it off and forget about it, and then the small leak turns into a huge flood when you’re off shopping or on vacation.